Thu Aug 24th 2017
The record charts used to be called the BBC hit parade. And a hit was a successful tune or song. There was even a quiz panel TV programme called ‘Juke Box Jury’ where celebrities predicted new songs to be hits or misses. Since those days, a number of other charts have cropped up in other areas; top ten TV personalities of the year, top five films, top five holiday destinations etc. In the world of building and construction, it is unlikely that anyone has come up with popularity charts for products and systems. It might be a fun exercise for people operating within the industry, but most of us are too busy to be speculating in areas of pure interest. It could be said that it simply wouldn’t be particularly productive to get side tracked with popularity charts for the purposes of amusement. However, there is an exception to that notion. The BBA have introduced a top five chart with a difference. Our Test Services team have put together the following:
Far from being a concept born of idle curiosity, it is intended to be helpful and informative to manufacturers wishing to avoid common pitfalls when commissioning often costly testing and assessment procedures to obtain BBA Agrément Certificates.
So for your entertainment, as well as the benefit of innovators everywhere, here are the top five in the current BBA Miss Parade:
If a product is being built or assembled onsite for testing, we are required to observe this without interference. If the installation is performed incorrectly and not to standard, we clearly cannot perform the necessary assessments. Similarly, some products are delivered incorrectly assembled. For example, where we are assessing an exposed surface condition, that surface needs to be free from extraneous materials. Some items have been tampered with to such an extent that external substances cannot be removed without damage to the product surface.
Sometimes the product does not meet the specification requirements of the standard. For example, samples submitted for thermal conductivity tests are required to be smooth and flat with parallel surfaces to enable good contact between the specimen and the plates of the Heat Flow Meter. They also need to be of certain dimensions to allow testing using specially designed equipment.
Occasionally samples are not packaged adequately to protect them in transit; they become exposed to moisture and/or damaged beyond use, often with missing or illegible labelling making it difficult or impossible to identify different batches/lots.
The definitive evidence of failure is moisture crossing the cavity, manifesting as damp areas on the block walls. Likely reasons for this will vary according to the type of material used. These can include inadequate fills, inadequate product properties, poor installation or unsuitable equipment, inappropriate cavity width for certain product types. All these can contribute to failure, allowing water/damp to travel across to the inner wall.
With ETICs systems, wind loading failures are due to pull through of fixings (either through the insulation or sheathing) or pull out of fixing from masonry or sheathing, or delamination of render from insulation. Note: The absolute number one cause of these failures is poor installation.
In the Building and Construction industry, if a new product is issued with a BBA Certificate, and subsequently becomes a hit in the market place, it will have nothing to do with hype or chance, just pure innovation genius combined with first class testing expertise. Some manufacturers whose products come close but fail at the end of the day may come away with a feeling that life has treated them unfairly. But then is life fair? The jury’s still out on that one.